2017-6-22 10:43
support1
GodexG500的列印條碼設置(48*19)
[size=5]首先進入控制台的檢視裝置及印表機
[img]http://www.pericles.net/ftp1/support1/Godex500setting/Godex500settingdriver1.JPG[/img]
[img]http://www.pericles.net/ftp1/support1/Godex500setting/Godex500settingdriver2.JPG[/img]
[img]http://www.pericles.net/ftp1/support1/Godex500setting/Godex500settingPOS1.JPG[/img]
如果以上設置也不能成功列印條碼,可以試試放上條碼紙後按FEED鍵,看看有沒有紅燈。
-如有,可以先看看條碼機出紙位的感應器(條碼紙的正下方)是否在右手邊,如不是請移動至最右邊。
-再重覆按FEED鍵看看有沒有紅燈,如有就要進行以下的定位偵測及自我測試頁。
定位偵測及自我測試頁:
1.放上條碼紙。
2.關閉電源,按住FEED鍵。
3.打開電源(此時仍按住FEED鍵不放),等待至閃紅燈後放開FEED鍵**,就會開始定位偵測及自我測試。
4.就會列印出相關的設定內容出來。(可參考以下說明書的20頁)
5.再試試可否成功列印條碼。
**如再持續按下FEED鍵(三秒)會變更為不同的測試或設定
Ready / Status
-------------------------------
a. Auto sensing (Orange(flash) / Orange)
b. Direct Thermal (Red(flash) / Red)
c. Thermal Transfer (Orange(flash) / Red)
G500條碼打印機的說明書:[url=http://www.godexintl.com/upload/media/Downloads/Manuals/tw/G500_UM_TC_121107.pdf]G500說明書[/url][/size]
[[i] 本帖最後由 support1 於 2018-5-16 11:21 編輯 [/i]]